IMPORTANT – READ ENTIRE LABEL BEFORE USE
Always test on an inconspicuous area first.
For best results apply in ambient temperature of 21°C (70°F) or above.
Disassemble units composed of moveable parts before applying remover. Clean parts and allow to dry before reassembling.
Turn sprayer to “SPRAY” position and apply remover liberally to the surface. Continue to apply the remover as needed, keeping the surface wet until the rust is dissolved. Once the rust is dissolved, rinse or wipe the surface, and wait one hour or more before painting. Do not allow remover to dry on painted surfaces.
For improved paint adhesion on clean metal surfaces, apply solution, let stand for 5-10 minutes and rinse or wipe the surface with a clean cloth.
To use as a rust inhibitor on unpainted metal, wipe the surface with a clean cloth after the rust is dissolved. The remover will then protect bare metal against rust for up to 12 months.
Do not use on non-metal surfaces. Do not use on marble.
DISSOLVING RUST FROM IRON OR STEEL: Turn sprayer to “SPRAY” position and apply remover liberally to the surface. Continue to apply the remover as needed, keeping the surface wet until the rust is dissolved. Chemical action begins at once. Cleaning time will vary according to the severity of the rust. Medium to light rust will be dissolved in 10-30 minutes or less, while heavier deposits may require a second application. Once the rust is dissolved, rinse with water and wipe the surface dry. After one hour or more, the surface is ready to be painted.
ALUMINUM/CHROME: Apply the remover to wet surface. Allow time to dissolve the rust; then rinse away with clean water and buff dry with a cloth.
GALVANIZED SURFACE: Where surface is unbroken, treat as suggested for aluminum. Where rust is showing at the surface, treat as for iron or steel. New galvanizing is properly prepared for painting by applying the remover, allowing 3-5 minutes to work and then wiping the surface clean.
BATHROOM/SHOWER/TOILET CLEANER:
Dissolves most calcium, lime and other hard water stains on porcelain, tile, fiberglass, and glass. Spray remover directly onto surface. Let sit for 5 minutes. Agitation with brush will speed penetration.