IMPORTANT – READ ENTIRE LABEL BEFORE USE
Application – For best results, apply a thin, even coating of Concrobium Mold Control to the surface, and allow to dry thoroughly. Once dry, use product to clean any residual staining. If staining persists, use Concrobium Mold Stain Remover to completely remove all mold staining. Once mold stain has been removed, leave a thin, even coating of Concrobium Mold Control® on the surface to provide protection
against future mold growth.
Application techniques – Roller, brush, rag, garden sprayer. Can also be applied with a cold fogging machine to treat large or inaccessible areas.
Coverage – Coverage varies according to surface and application method.
Fogging: approximately 1,400 sq. ft. per gallon (the equivalent of a 20’ x 20’ room with 8 foot ceilings, all
surfaces).
Spray (manual or compression sprayer): Approx. 500 sq. ft. per gallon depending on sprayer type and surface absorbency.
Expect reduced coverage on absorbent surfaces such as fabrics, carpet, lumber and unpainted drywall.
Special application instructions – Do not dilute. Do not rinse. Do not use bleach-based products in
combination as this may reduce product efficacy.
Handling – No special controls, ventilation, or personal protective equipment is required while handling the product. To avoid applicator exposure to mold or mold spores during use, consult product label section: “PERSONAL PROTECTION EQUIPMENT REQUIREMENTS FOR APPLICATORS”.
Storage – Store containers between 39°F and 100°F. If product freezes, thaw and mix thoroughly